LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2005 >> Vibe Base, FWD, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Automatic Transmission - Mu5) >> Diagnostic Information and Procedures >> DTC P2716 >> Test Description

Test Description

WARNING: This page is about a different variant/trim than selected.

The number below refers to the step number on the diagnostic table.

  1. 2:  Listen for an audible click when the solenoid energizes.
DTC P2716

Step Action Value(s) Yes No
Schematic Reference: Automatic Transmission Controls Schematics
1 Did you perform the Diagnostic System Check - Vehicle? - Go to Step 2  Go to Diagnostic System Check - Vehicle in Vehicle DTC Information
2 
  1. Install a scan tool.
  2. Turn ON the ignition with the engine OFF.
    3. IMPORTANT:
    • Before clearing the DTC, use the scan tool in order to record the PCM Freeze Frame Failure Records. Using the Clear Info function erases the Freeze Frame Failure Records from the powertrain control module (PCM).
    • Using the Clear Info function erases stored DTCs in the PCM.
  3. Record the DTC Freeze Frame and Failure Records.
  4. Clear the DTC.
  5. Use the scan tool in order to command the solenoid ON.
Does the solenoid operate?		 - Go to Step 5  Go to Step 3 
3
  1. Turn OFF the ignition.
  2. Disconnect the PCM.
  3. Test the circuit from the PCM to the line pressure solenoid for a open or short to ground in the circuit. Refer to Testing for Short to Ground in Wiring Systems.
Did you find a condition?		 - Go to Step 6  Go to Step 5 
4
  1. Remove the transmission oil pan.
  2. Test the line pressure solenoid wiring from the 10-way connector to the solenoid connector for the following conditions:
Did you find a condition?		 - Go to Step 7  Go to Step 8 
5 Replace the PCM. Refer to Powertrain Control Module Programming and Setup in Programming and Setup.
 
Is the action complete?		 - Go to Step 9  -
6 Perform the necessary wiring repairs. Refer to Wiring Repairs in Wiring Systems.
Is the action complete?		 - Go to Step 9  -
7 Replace the internal transmission wiring harness. Refer to Solenoids and Wiring Harness Replacement .
Is the action complete?		 - Go to Step 9  -
8 Replace the line pressure solenoid valve. Refer to Solenoids and Wiring Harness Replacement .
Is the action complete?		 - Go to Step 9  -
9 Perform the following procedure in order to verify the repair:
  1. Select DTC.
  2. Select Clear Info.
  3. Turn ON the ignition, with the engine OFF.
  4. Select Specific DTC.
  5. Enter DTC P2716.

Has the test run and passed?		 - Go to Step 10  Go to Step 2 
10 With the scan tool, observe the stored information, capture info and DTC info.
Does the scan tool display any DTCs that you have not diagnosed?		 - Go to Diagnostic Trouble Code (DTC) List - Vehicle in Vehicle DTC Information System OK
scientia non olet · About LEMON Manuals