LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2005 >> Vibe Base, FWD, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Engine Control System - 1.8L (LNK) - Introduction) >> Repair Instructions >> Idle Air Control (IAC) Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Throttle Body, Coolant Hoses, IAC Valve And Gasket
    GM828869Courtesy of GENERAL MOTORS CORP.
  1. Install a new IAC valve gasket (4).
  2. Install the IAC valve (3) to the throttle body.
    3. NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  3. Install the fasteners that retain the IAC valve.

    Tighten:  Tighten the fasteners to 3.7 N.m (33 lb in).

  4. Connect the two coolant hoses (2) to the IAC valve.
    5. Fig 2: View Of Idle Air Control (IAC) Valve And Electrical Connector
    GM828867Courtesy of GENERAL MOTORS CORP.
  5. Connect the electrical connector (2) to the IAC valve (1).
  6. Refill the cooling system. Refer to Draining and Filling Cooling System in Engine Cooling.
scientia non olet · About LEMON Manuals