LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2005 >> Vibe Base, FWD, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Engine Control System - 1.8L (LNK) - Introduction) >> Repair Instructions >> Evaporative Emission (EVAP) Canister Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of EVAP Canister Components
    GM1459178Courtesy of GENERAL MOTORS CORP.
  1. Install the EVAP canister (3) to the vehicle underbody and secure with 3 bolts.
    2. NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Tighten the EVAP canister bracket support bolts.

    Tighten:  Tighten the bolts to 19 N.m (14 lb ft).

  3. Connect the EVAP purge hose (1) to the EVAP canister (3).
  4. Connect the electrical connector (4) to the EVAP canister vacuum pump.
  5. Connect the ORVR vent line (2) to the EVAP canister (3).
  6. Slide the locking clasp of the quick connect fitting into the lock position on the ORVR vent line
    7. Fig 2: View Of EVAP Canister Inlet Line And Vent Pipe
    GM1468453Courtesy of GENERAL MOTORS CORP.
  7. Connect the EVAP canister air inlet line (1) to the vent pipe (2).
  8. Lower the vehicle.
scientia non olet · About LEMON Manuals