Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Fig 1: View Of CMP Actuator Solenoid Valve And O-Ring

Courtesy of GENERAL MOTORS CORP.

Install a new O-ring (2) and the CMP actuator solenoid valve (1) into the cylinder head.

NOTE: Refer to FASTENER NOTICE in Cautions and Notices.

Secure the CMP actuator solenoid valve with the fastener.
Tighten: Tighten the fastener to 9 N.m (80 lb in).

Fig 2: View Of Electrical Connector And Solenoid Valve

Courtesy of GENERAL MOTORS CORP.

Fig 3: View Of PCV Breather Pipe, Hose, Support Brace, Nuts And Bolts

Courtesy of GENERAL MOTORS CORP.

Connect the PCV breather hose (4) to the PCV breather pipe (3).
Install the PCV breather pipe (3), with a new gasket (2), to the cylinder head.
Secure the PCV breather pipe to the cylinder head with the two nuts (1).
Tighten: Tighten the fastener to 9 N.m (80 lb in).
Secure the lower portion of the PCV breather pipe (3) to intake manifold with the one bolt (5).
Tighten: Tighten the bolts to 24 N.m (18 lb ft).
Install the generator support brace to the intake manifold and secure with two bolts.
Tighten: Tighten the bolts to 29 N.m (21 lb ft).

Fig 4: View Of Engine Upper Cover

Courtesy of GENERAL MOTORS CORP.

Install the engine cover (1) to the engine.
Secure the engine cover (1) with the four fasteners.
Tighten: Tighten the fasteners to 7 N.m (62 lb in).