LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2005 >> Vibe Base, FWD, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Engine Control System - 1.8L (LNK) - Introduction) >> Repair Instructions >> Auxiliary Intake Air Control Solenoid Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Electrical Connector, Vacuum Lines, Air Control Solenoid And Fasteners
    GM833867Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  1. Install the auxiliary intake air control solenoid (3) to the air cleaner housing with the two fasteners (4).

    Tighten:  Tighten the fasteners to 3.7 N.m (33 lb in).

  2. Connect the 2 vacuum hoses (2) to the auxiliary intake air control solenoid (3).
  3. Connect the electrical connector.
scientia non olet · About LEMON Manuals