LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2005 >> Vibe Base, FWD, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Mechanical - 1.8L (LNK)) >> Repair Instructions >> On-Vehicle Repair Instructions >> Drive Belt Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    CAUTION: Refer to Battery Disconnect Caution in Cautions and Notices.
  1. Disconnect the negative battery cable.
    2. Fig 1: Repositioning Wiring Harness Clamp Bracket
    GM1238958Courtesy of GENERAL MOTORS CORP.
  2. Remove the bolt, then reposition the wiring harness clamp bracket.
    3. Fig 2: Removing/Installing 2 Nuts
    GM1238961Courtesy of GENERAL MOTORS CORP.
  3. Remove the 2 nuts, then reposition the A/C hose aside.
    4. Fig 3: Serpentine Drive Belt Routing
    GM244267Courtesy of GENERAL MOTORS CORP.
  4. Use a wrench and rotate the belt tensioner clockwise.
  5. With pressure applied to the wrench, and tension relieved from the drive belt, remove the accessory drive belt.
scientia non olet · About LEMON Manuals