LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2005 >> Vibe Base, FWD, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Mechanical - 1.8L (LNK)) >> Repair Instructions >> On-Vehicle Repair Instructions >> Crankshaft Pulley Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    CAUTION: Refer to Battery Disconnect Caution in Cautions and Notices.
  1. Disconnect the negative battery cable.
  2. Remove the accessory drive belt. Refer to Drive Belt Replacement .
  3. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  4. Remove the right splash shield.
    5. Fig 1: Removing Crankshaft Pulley Retaining Bolt
    GM234153Courtesy of GENERAL MOTORS CORP.
  5. Remove the crankshaft pulley retaining bolt using J 8614-01  to prevent crankshaft rotation when loosening the bolt.
scientia non olet · About LEMON Manuals