LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2005 >> Vibe Base, FWD, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Manual Transmission - MTN) >> Repair Instructions >> Vehicle Speed Sensor (VSS) Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    CAUTION: Refer to Battery Disconnect Caution in Cautions and Notices.
  1. Disconnect the negative battery cable.
    2. Fig 1: VSS Electrical Connector
    GM242756Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the vehicle speed sensor (VSS) electrical connector (1).
  3. Remove the 1 retaining bolt and the VSS from the transaxle.
  4. Inspect the VSS O-ring for cuts or damage. Replace as necessary.
scientia non olet · About LEMON Manuals