Installation Procedure

WARNING: This page is about a different variant/trim than selected.

NOTE: When removing or installing the backup lamp switch, do not use an open end wrench. Use only a socket in order to avoid damage to the switch assembly.

Fig 1: Backup Light Switch Assembly

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the backup light switch with a new gasket.
Tighten: Tighten the switch to 40 N.m (30 lb ft).

Fig 2: Backup Lamp Connector

Courtesy of GENERAL MOTORS CORP.

Connect the backup lamp connector.