LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2005 >> Vibe Base, FWD, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Manual Transmission Clutch System) >> Repair Instructions >> Clutch Pedal Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Position the clutch pedal assembly in the vehicle.
  2. Connect the CPP switch electrical connector.
  3. Connect the CCR switch electrical connector.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
    Fig 1: Pedal Assembly Bracket Retaining Nuts And Retaining Bolt
    GM885331Courtesy of GENERAL MOTORS CORP.
  4. Install the 2 clutch pedal retaining nuts and 1 bolt.

    Tighten: 

    • Tighten the retaining nuts to 12 N.m (106 lb in).
    • Tighten the retaining bolt to 19 N.m (14 lb ft).

    5. Fig 2: Removing/Installing Clevis Clip And Pin
    GM885330Courtesy of GENERAL MOTORS CORP.
  5. Install the clevis clip and the pin.
  6. Install the Lower Instrument Panel. Refer to Instrument Panel (I/P) Trim Panel Replacement - Lower .
  7. Connect the negative battery cable.
scientia non olet · About LEMON Manuals