LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2005 >> Vibe Base, FWD, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Manual Transmission Clutch System) >> Repair Instructions >> Clutch Actuator Cylinder Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Clutch Actuator Cylinder Bolts
    GM887464Courtesy of GENERAL MOTORS CORP.
  1. Install the clutch actuator cylinder to the transaxle.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the clutch actuator cylinder bolts.

    Tighten:  Tighten the clutch actuator cylinder bolts to 12 N.m (9 lb ft).

    3. Fig 2: Clutch Actuator Cylinder Fluid Line
    GM887462Courtesy of GENERAL MOTORS CORP.
  3. Install the clutch actuator cylinder fluid line to the clutch actuator cylinder.
  4. Bleed the hydraulic clutch system. Refer to Hydraulic Clutch Bleeding  .
scientia non olet · About LEMON Manuals