Installation Procedure

Install the striker (3) to the I/P carrier (1).
Install the screws (2) to the striker (3).

Fig 1: Identifying (I/P) Compartment Striker Screws
Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Adjust the striker (3) for proper alignment to the I/P compartment.
Tighten: Tighten the screws to 2.3 N.m (20 lb in).
Install the I/P trim pad. Refer to Trim Pad Replacement - Instrument Panel (I/P) (Pontiac) or Trim Pad Replacement - Instrument Panel (I/P) (Chevrolet) .