Conditions for Setting the DTC
WARNING: This page is about a different variant/trim than selected.
- The output state of the supercharger boost control solenoid driver detects an open or an over-temperature condition for at least 15 out of 20 samples. Each sample is 100 ms. The powertrain control module (PCM) detects that the output state of the supercharger boost control solenoid driver is incorrect or excessive current is detected for more than 2 seconds.
OR
- The output state of the supercharger boost control solenoid driver detects a short for at least 5 out of 10 samples. Each sample is 12.5 ms. The PCM detects that the output state of the supercharger boost control solenoid driver is shorted for more than 1 second.
- This diagnostic runs continuously.