Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- Position the right engine mount strut bracket over the pin locator.
- Install the bolts through the right engine mount strut bracket to the cylinder head.
Tighten: Tighten the engine mount strut bracket bolt to 50 N.m (37 lb ft).
- Install the air conditioner compressor. Refer to Compressor Replacement (L26 L32)
in Heating, Ventilation, and Air Conditioning.
Tighten: Tighten the air conditioning compressor mounting bolts to 50 N.m (37 lb ft).
- Install the right engine mount strut to the right engine mount strut bracket.
- Connect the battery ground (negative) cable. Refer to Battery Negative Cable Disconnect/Connect Procedure (RPOs L26/L32) in Engine Electrical.
NOTE:
Refer to Fastener Notice in Cautions and Notices.