LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2005 >> Grand Prix GXP >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Mechanical - 3.8L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Engine Mount Strut Bracket Replacement - Left >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Left Engine Mount Strut Bracket & Bolts
    GM35814Courtesy of GENERAL MOTORS CORP.
  1. Install the engine mount strut bracket to the head.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the engine mount strut bracket bolts.

    Tighten:  Tighten the bolts to 50 N.m (37 lb ft).

    3. Fig 2: Left Engine Mount Strut Bolt & Nut
    GM327466Courtesy of GENERAL MOTORS CORP.
  3. Install the engine mount strut to the left engine mount strut bracket. Refer to Engine Mount Strut Replacement - Left  and Engine Mount Strut Replacement - Right .
  4. Install the engine coolant temperature sensor. Refer to Engine Coolant Temperature (ECT) Sensor Replacement in Engine Controls - 3.8L (L26 and L32).
  5. Fill the cooling system with engine coolant. Refer to Draining and Filling Cooling System (L26 and L32) in Engine Cooling.
scientia non olet · About LEMON Manuals