Intake Manifold Installation - Lower (L32)

WARNING: This page is about a different variant/trim than selected.

Fig 1: Lower Intake Manifold (L32)

Courtesy of GENERAL MOTORS CORP.

Clean the lower intake manifold sealing surface using GM P/N 12346139 (Canadian P/N 10953463) or equivalent prior to installing any seals or gaskets.
Install the lower intake manifold gasket.
Install the lower intake manifold.
Apply Threadlocker 272 GM P/N 12345493, (Canadian P/N 10953488) to the bolt threads.

Fig 2: Identifying Lower Intake Manifold Bolt Tightening Sequence

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the lower intake manifold bolts including the two hidden bolts.
Tighten: Tighten the bolts in sequence to 15 N.m (11 lb ft).