LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2005 >> Grand Prix GXP >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Mechanical - 3.8L) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Intake Manifold Installation - Lower (L26)

Intake Manifold Installation - Lower (L26)

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Lower Intake Manifold Bolt Tightening Sequence
    GM44774Courtesy of GENERAL MOTORS CORP.
  1. Clean the lower intake manifold sealing surface using GM P/N 12346139 (Canadian P/N 10953463) or equivalent prior to installing any seals or gaskets.
  2. Install the lower intake manifold gasket.
  3. Install the lower intake manifold.
  4. Apply threadlocker 272 GM P/N 12345493, (Canadian P/N 10953488) or the equivalent to the bolt threads.
    5. NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Install the lower intake manifold bolts.

    Tighten:  Tighten the lower intake manifold bolts in sequence to 15 N.m (11 lb ft).

    6. Fig 2: Generator Brace Bracket
    GM1335973Courtesy of GENERAL MOTORS CORP.
  6. Install the generator brace bracket (571).
  7. Install the generator brace bracket bolts (569, 570).

    Tighten:  Tighten the generator brace bracket bolts to 50 N.m (37 lb ft).

scientia non olet · About LEMON Manuals