LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2005 >> Grand Prix GXP >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Controls - 3.8L - Introduction) >> Repair Instructions >> Fuel Pressure Gage Installation and Removal >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Fuel Pressure Gauge J 34730-1A
    GM180378Courtesy of GENERAL MOTORS CORP.
  1. Remove the bleed hose on the J 34730-1A  from the approved container. See Special Tools .
  2. Remove the shop towel from around the fitting and discard into an approved container.
  3. Disconnect the J 34730-1A  from the fuel pressure valve. See Special Tools .
  4. Install the fuel pressure fitting cap.
scientia non olet · About LEMON Manuals