Installation Procedure

Fig 1: View Of Compartment & Upper Trim Plate (Front Floor)

Courtesy of GENERAL MOTORS CORP.

Fig 2: View Of Compartment & Screws (Front Floor)

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the compartment screws.
Tighten: Tighten the screws to 2 N.m (18 lb in).

Fig 3: View Of Side Trim Panel Screws (Front Floor)

Courtesy of GENERAL MOTORS CORP.

Align the side trim panels to the locators.
Install the side trim panel screws.
Tighten: Tighten the screws to 2 N.m (18 lb in).

Fig 4: View Of Compartment Screws (Front Floor)

Courtesy of GENERAL MOTORS CORP.

Install the compartment screws.
Tighten: Tighten the screws to 2 N.m (18 lb in).

Fig 5: View Of Rear Cover (Front Floor)

Courtesy of GENERAL MOTORS CORP.

Fig 6: View Of Rear Cover Screws (Front Floor)

Courtesy of GENERAL MOTORS CORP.

Install the rear cover screws.
Tighten: Tighten the screws to 2 N.m (18 lb in).
Install the armrest and the hinge. Refer to Console Armrest Replacement - Front Floor .
Install the accessory power receptacles. Refer to Cigar Lighter Housing Replacement - Floor Console and to Accessory Power Receptacle Replacement - Floor Console in Power Outlets.
Install the traction control switch. Refer to Traction Control Switch Replacement in Antilock Brake System.
Install the HUD switch, if equipped. Refer to Head Up Display Switch Replacement .
Install the wiring harness.
Install the cupholder liner.
Install the ashtray insert.
Install the floor console. Refer to Console Replacement - Front Floor .