Removal Procedure

Fig 1: Identifying Ignition Cylinder Bezel

Courtesy of GENERAL MOTORS CORP.

Use a plastic trim tool to remove the ignition switch bezel.
Pull the I/P accessory trim plate rearward slightly for access to the steering column filler. Refer to Trim Plate Replacement - Instrument Panel (I/P) Accessory .

Fig 2: Left Knee Bolster Screws

Courtesy of GENERAL MOTORS CORP.

Remove the I/P steering column filler. Refer to Steering Column Filler Replacement .
Remove the knee bolster screws at the lower I/P trim pad.

Fig 3: Left Knee Bolster Bolts

Courtesy of GENERAL MOTORS CORP.

Fig 4: Harness Retainer & Driver Side Knee Bolster

Courtesy of GENERAL MOTORS CORP.

Remove the harness retainer from the knee bolster. Remove the driver side knee bolster.