Installation Procedure
- Align the I/P compartment to the I/P.
- Install the I/P compartment lamp switch to the opening in the I/P compartment.
- Connect the electrical connector to the I/P compartment lamp switch.
- Install the wiring harness retainers to the rear of the I/P compartment.
- Align the I/P compartment to the I/P trim pad. Install the I/P compartment screws.
Tighten: Tighten the screws to 2 N.m (18 lb ft).
- Align the I/P inboard trim plate retainers to the slots in the I/P carrier. Press the trim plate to engage the retainers.
- Install the I/P accessory trim plate. Refer to Trim Plate Replacement - Instrument Panel (I/P) Accessory .
- Engage the door stop using the following procedure:
- Press the upper door stop (2) toward the center of the vehicle.
- Rotate the door up to the compartment.
- Close the I/P compartment.
- Position the I/P outboard trim plate retainers to the slots in the I/P carrier.
- Install the I/P trim plate by pressing the panel straight into the I/P carrier.
- Align the access hole cover for the right I/P compartment to the I/P trim pad. Press the cover to the trim.
NOTE:
Refer to Fastener Notice
in Cautions and Notices.