Removal Procedure

Remove the garnish moldings from the left and the right windshield pillars. Refer to Garnish Molding Replacement - Windshield Pillar in Interior Trim.

Fig 1: View Of Upper Trim Panel & Head Up Display

Courtesy of GENERAL MOTORS CORP.

NOTE: Use the following method to disengage the Head Up Display (HUD) retainers. Do NOT pry the retainers with a flat-bladed tool or other similar device.

Disengage the I/P upper trim panel retainers on the sides of the HUD.
Disengage the retainer rearward of the HUD.

Failure to follow this method could break the tab on the HUD.

Use your fingers to lift under the edge of the I/P upper trim panel adjacent to the trim clips. If equipped, disengage the trim panel retainers on the sides of the Head Up Display (HUD) first.

Fig 2: View Of HUD & Trim Panel

Courtesy of GENERAL MOTORS CORP.

Disengage the retainer rearward of the HUD.
Disengage the remaining trim panel retainers. Lift the trim panel for access.

Fig 3: DRL Ambient Light Sensor

Courtesy of GENERAL MOTORS CORP.

Use clean shop towels to protect the I/P trim pad from the trim panel retainers. Rotate the Daytime Running Lamp (DRL) ambient light sensor.
Remove the sensor from the trim panel.

Fig 4: View Of Theft LED

Courtesy of GENERAL MOTORS CORP.

Rotate the Theft LED.

Fig 5: View Of Electrical Connector & Theft LED

Courtesy of GENERAL MOTORS CORP.

Remove the LED from the trim panel.

Fig 6: View Of I/P Upper Trim Panel

Courtesy of GENERAL MOTORS CORP.

Remove the I/P upper trim panel.