LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2005 >> Grand Prix GTP >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel System Displays, Gauges And Console >> Repair Instructions >> Knee Bolster Replacement - Left >> Installation Procedure

Installation Procedure

    Fig 1: Harness Retainer & Driver Side Knee Bolster
    GM928918Courtesy of GENERAL MOTORS CORP.
  1. Install the harness retainer to the knee bolster. Verify that the harness is not pinched between the bolster bracket and the I/P carrier cross car beam.
    2. Fig 2: Left Knee Bolster Bolts
    GM929383Courtesy of GENERAL MOTORS CORP.
  2. Align the knee bolster to the I/P.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Start the bolts by hand to avoid cross threading. Install the knee bolster bolts to the I/P carrier cross car beam.

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

    4. Fig 3: Left Knee Bolster Screws
    GM928866Courtesy of GENERAL MOTORS CORP.
  4. Install the knee bolster screws at the I/P lower trim panel.

    Tighten:  Tighten the screws to 2 N.m (18 lb in).

  5. Install the steering column filler. Refer to Steering Column Filler Replacement .
  6. Install the I/P accessory trim plate. Refer to Trim Plate Replacement - Instrument Panel (I/P) Accessory .
    7. Fig 4: Identifying Ignition Cylinder Bezel
    GM910510Courtesy of GENERAL MOTORS CORP.
  7. Install the ignition switch bezel.
scientia non olet · About LEMON Manuals