Removal Procedure

Fig 1: Right I/P Compartment Access Hole Cover

GM1203017

Courtesy of GENERAL MOTORS CORP.

Using the finger opening, remove the access hole cover from the right instrument panel (I/P) compartment.

Fig 2: I/P Trim Plate (Glove Box Outboard)

GM929385

Courtesy of GENERAL MOTORS CORP.

Pull the I/P outboard trim plate rearward in order to release the retainers.
Remove the I/P trim plate.
Open the I/P compartment.

Fig 3: View Of Upper Door Stop

GM1332713

Courtesy of GENERAL MOTORS CORP.

Disengage the compartment door stop using the following procedure:
1. Press the upper door stop (2) toward the center of the vehicle.
2. Rotate the door away from the compartment.
Pull the I/P accessory trim plate rearward slightly for access to the I/P inboard trim plate. Refer to Trim Plate Replacement - Instrument Panel (I/P) Accessory .

Fig 4: View Of I/P Trim Plate

GM929399

Courtesy of GENERAL MOTORS CORP.

Pull the I/P inboard trim plate toward the passenger door opening. Remove the I/P trim plate.

Fig 5: I/P Compartment Screws

GM929431

Courtesy of GENERAL MOTORS CORP.

Remove the I/P compartment screws.

Fig 6: Wiring Harness Retainers

GM928591

Courtesy of GENERAL MOTORS CORP.

Disconnect the wiring harness retainers at the rear of the I/P compartment.

Fig 7: I/P Compartment Lamp Switch

GM1202641

Courtesy of GENERAL MOTORS CORP.

Pull the I/P compartment from the I/P.
Disconnect the electrical connector from the I/P compartment lamp switch.
Remove the I/P compartment lamp switch.

Fig 8: View Of I/P Compartment

GM929257

Courtesy of GENERAL MOTORS CORP.

Remove the I/P compartment.