Conditions for Clearing the DTC
- The DTC becomes history when the DIC no longer detects a failure.
- The history DTC clears after 100 fault-free ignition cycles.
- The DIC receives the clear code command from the scan tool.
DTC B0931
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: Driver Information System Schematics | |||
| 1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | Go to Diagnostic System Check - Vehicle in Vehicle DTC Information |
| 2 | Is the vehicle equipped with a sunroof? | Go to Step 3 | Go to Step 4 |
| 3 | Inspect for poor connections at the harness connector of the compass. Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 5 | Go to Step 4 |
| 4 | Replace the driver information center (DIC). Refer to Control Module References
in Computer/Integrating Systems for replacement, setup, and programming. Did you complete the replacement? |
Go to Step 5 | - |
| 5 |
|
Go to Step 2 | System OK |