LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2005 >> GTO Standard >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel System Displays, Gauges And Console >> Repair Instructions >> Bracket Replacement - Instrument Panel (I/P) End Left >> Installation Procedure

Installation Procedure

    Fig 1: View Of End Left Bracket & Screws
    GM1363465Courtesy of GENERAL MOTORS CORP.
  1. Install the end left bracket assembly (3) to the dash panel.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the screw (2) attaching the end left bracket (3) to the dash panel.

    Tighten:  Tighten the screw to 9 N.m (80 lb in).

  3. Install the screw (1) attaching the end left bracket (3) to the steering column bracket.

    Tighten:  Tighten the screw to 9 N.m (80 lb in).

  4. Install the screw (4) attaching the end left bracket (3) to the vehicle.

    Tighten:  Tighten the screw to 9 N.m (80 lb in).

  5. Install the driver's knee bolster reinforcement. Refer to Knee Bolster Reinforcement Replacement .
    6. Fig 2: View Of Lever Assembly, Bracket & Retaining Tabs
    GM1236078Courtesy of GENERAL MOTORS CORP.
  6. Install the hood latch release cable lever (3) to the bracket (2), ensuring the retaining tabs (1) fasten.
  7. Install the fuse and relay panel.
  8. Install the instrument panel pad. Refer to Trim Pad Replacement - Instrument Panel (I/P) Upper .
scientia non olet · About LEMON Manuals