LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2005 >> GTO Standard >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel System Displays, Gauges And Console >> Diagnostic Information and Procedures >> DTC B0022: Trip Computer Switch Button Stuck >> Diagnostic Aids

Diagnostic Aids

By manipulating the harnesses at the various connectors it is often possible to isolate the cause of the circuit interruption. This harness can then be removed and repaired. Check for any damage to the harness, which could cause an intermittent open or short to earth or backed out terminals at the instrument cluster connectors, broken connector locks, improperly formed or damaged terminals.

DTC 22 - Trip Computer Switch Button Stuck

Step Action Yes No
1 Did you perform the Diagnostic System Check - Vehicle? Go to Step 2  Go to Diagnostic System Check - Vehicle
2
  1. Install a scan tool.
  2. Turn the ignition ON, with the engine OFF.
Can the Tech 2 communicate with the body control module (BCM)?		 Go to Step 3  Go to Diagnostic Starting Point - Computer/Integrating Systems
3 Inspect the switch for obvious signs of a stuck button.
Is a stuck button present?		 Go to Step 4  Go to Step 5 
4 Replace the trip computer switch. Refer to Driver Information Center Switch Replacement .
Did you complete the repair?		 Go to Step 5  -
5
  1. Use the scan tool in order to clear the DTCs.
  2. Operate the vehicle within the Conditions for Running the DTC as specified in the supporting text.
Does the DTC reset?		 Go to Step 2  System OK
scientia non olet · About LEMON Manuals