Diagnostic Aids

WARNING: This page is about a different variant/trim than selected.

IMPORTANT:

Do not clear the DTC unless directed by a diagnostic procedure. Clearing the DTC(s) will erase all Freeze Frame and Failure Records stored in PCM memory.
Poor engine performance can sometimes be diagnosed as a transmission driveability condition. In order to avoid mis-diagnosis of the automatic transmission, always perform Diagnostic System Check - Engine Controls in Engine Controls.

Use a Scan Tool that is known to function correctly. If necessary, test the Scan Tool on another vehicle.
Ensure the Scan Tool contains the most current file available.
The Scan Tool will display a loss of communication error message under the following conditions:
- PCM power is interrupted.
- The ignition switch is turned OFF.
- The battery voltage level is very low.
- A poor connection is present at the diagnostic link connector (DLC).