LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2004 >> Vibe GT >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Engine Control System (Introduction) - 1.8L (LV6)) >> Repair Instructions >> Throttle Position (TP) Sensor Replacement (AWD) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Throttle Body, TP Sensor And Throttle Shaft (AWD)
    GM850215Courtesy of GENERAL MOTORS CORP.
  1. Align the throttle shaft (3) with the slot in the TP sensor (2).
  2. Install the TP sensor (2) to the throttle body (1).
    3. Fig 2: Fasteners And Electrical Connectors (AWD)
    GM229615Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Secure the TP sensor with the 2 fasteners (3).

    Tighten:  Tighten the fasteners to 2.0 N.m (18 lb in).

scientia non olet · About LEMON Manuals