LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2004 >> Vibe GT >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Engine Control System (Introduction) - 1.8L (LV6)) >> Repair Instructions >> Idle Air Control (IAC) Valve Replacement (AWD) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Idle Air Control (IAC) Valve And Electrical Connector (AWD)
    GM828871Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the electrical connector (2) to the idle air control (IAC) valve (1).
  2. Drain the cooling system. Refer to Draining and Filling Cooling System in Engine Cooling.
    3. Fig 2: Throttle Body, Coolant Hoses, IAC Valve, Fasteners And Valve Gasket (AWD)
    GM828873Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the two coolant hoses (2) to the IAC valve.
  4. Remove the fasteners retaining the IAC valve (3).
  5. Remove the IAC valve (4) from the throttle body (1).
  6. Remove any remaining IAC valve gasket (4).
scientia non olet · About LEMON Manuals