LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2004 >> Vibe GT >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Engine Control System (Introduction) - 1.8L (LV6)) >> Repair Instructions >> Evaporative Emission (EVAP) Pressure Switching Solenoid Replacement (AWD) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
NOTE: The EVAP canister may have released carbon particles which caused this part to fail and may cause damage to other components. Check the EVAP canister for loose carbon before returning the vehicle to service.
    Fig 1: EVAP Pressure Switching Solenoid, EVAP Canister And Fasteners
    GM625291Courtesy of GENERAL MOTORS CORP.
  1. Remove the EVAP canister (3). Refer to Evaporative Emission (EVAP) Canister Replacement (FWD)  or Evaporative Emission (EVAP) Canister Replacement (AWD) .
  2. Disconnect the electrical connector of the EVAP pressure switching solenoid.
  3. Disconnect the 2 vapor hoses.
  4. Remove the fastener (2).
  5. Remove the EVAP pressure switching solenoid (1) from the EVAP canister.
  6. Inspect the EVAP pressure switching solenoid and the EVAP control system for carbon particle contamination before replacing the EVAP pressure switching solenoid.
scientia non olet · About LEMON Manuals