LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2004 >> Vibe GT >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Engine Control System (Introduction) - 1.8L (LV6)) >> Repair Instructions >> Evaporative Emission (EVAP) Canister Vent Solenoid Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Inspect the EVAP canister vent solenoid valve and the EVAP control system for carbon particle contamination before replacing the EVAP canister vent solenoid.
    2. Fig 1: Canister Vent Valve, Vent Hose, Electrical Connector And Fastener
    GM832000Courtesy of GENERAL MOTORS CORP.
  2. Install the EVAP canister vent valve (3) to the air cleaner housing with the one fastener (2).
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Tighten the EVAP canister vent valve fastener (2).

    Tighten:  Tighten the fastener to 8.8 N.m (77 lb in).

  4. Connect the one vent hose (4) to the EVAP canister vent valve (3) and the air cleaner housing.
  5. Connect the other vent hose (4) to the EVAP canister vent valve (3).
  6. Connect the electrical connector (1) to the vent valve.
scientia non olet · About LEMON Manuals