LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2004 >> Vibe GT >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Engine Control System (Introduction) - 1.8L (LV6)) >> Repair Instructions >> Evaporative Emission (EVAP) Canister Replacement (AWD) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Disconnecting/Connecting EVAP Canister, Electrical Connector, EVAP Hoses And Bolts (AWD)
    GM832235Courtesy of GENERAL MOTORS CORP.
  1. Install the EVAP canister (3) to the vehicle underbody and secure with the 3 bolts (2).
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Tighten the EVAP canister bracket support bolts.

    Tighten:  Tighten the bolts to 19 N.m (14 lb ft).

  3. Connect the 3 EVAP hoses (1) to the EVAP canister (3).
  4. Connect the electrical connector (4) to the EVAP pressure switching solenoid.
    5. Fig 2: Disconnect/Connecting EVAP Vapor Line Of Hose Connector (AWD)
    GM832227Courtesy of GENERAL MOTORS CORP.
  5. Connect the EVAP vapor line (1) to the EVAP canister port by pinching both sides of the hose connector (1).
    6. Fig 3: Disconnect/Connecting ORVR Vent Line Of Hose Connector (AWD)
    GM832027Courtesy of GENERAL MOTORS CORP.
  6. Connect the ORVR vent line (1) to the EVAP canister port by pinching both sides of the hose connector (1).
  7. Lower the vehicle.
scientia non olet · About LEMON Manuals