LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2004 >> Vibe GT >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Engine Control System (Introduction) - 1.8L (LV6)) >> Repair Instructions >> Evaporative Emission (EVAP) Canister Purge Solenoid Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Canister Purge Valve, Electrical Connector, Purge Hose And Vacuum Hose
    GM832001Courtesy of GENERAL MOTORS CORP.
  1. Install the EVAP canister purge valve (2) to the air cleaner housing.
  2. Connect the purge hose (3) to the EVAP canister purge valve (2).
  3. Connect the vacuum hose (4) to the EVAP canister purge valve (2).
  4. Connect the electrical connector (1) to the EVAP canister purge valve (2).
scientia non olet · About LEMON Manuals