LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2004 >> Vibe GT >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Engine Control System (Introduction) - 1.8L (LV6)) >> Repair Instructions >> Camshaft Position (CMP) Actuator Solenoid Valve Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Engine Top Cover, Plastic Retainers And Fasteners
    GM856569Courtesy of GENERAL MOTORS CORP.
  1. Remove the 2 fasteners.
  2. Remove the 2 plastic retainers.
  3. Remove the engine cover (1) from the engine.
    4. Fig 2: (CMP) Actuator Solenoid Valve And Electrical Connector
    GM828858Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the electrical connector (1) from the camshaft position (CMP) actuator solenoid valve (2).
    5. Fig 3: (CMP) Actuator Solenoid Valve And O-Ring
    GM828860Courtesy of GENERAL MOTORS CORP.
  5. Remove the fastener retaining the CMP actuator solenoid valve (1) to the cylinder head.
  6. Remove the CMP actuator solenoid valve (1) and the O-ring (2) from the cylinder head.
scientia non olet · About LEMON Manuals