LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2004 >> Vibe GT >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Engine Control System (Introduction) - 1.8L (LV6)) >> Repair Instructions >> Camshaft Position (CMP) Actuator Solenoid Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: (CMP) Actuator Solenoid Valve And O-Ring
    GM828860Courtesy of GENERAL MOTORS CORP.
  1. Install a new O-ring (2) and the CMP actuator solenoid valve (1) into the cylinder head.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Secure the CMP actuator solenoid valve with the fastener.

    Tighten:  Tighten the fastener to 9 N.m (80 lb in).

    3. Fig 2: (CMP) Actuator Solenoid Valve And Electrical Connector
    GM828858Courtesy of GENERAL MOTORS CORP.
  3. Connect the electrical connector (1) to the solenoid valve (2).
    4. Fig 3: View Of Engine Top Cover, Plastic Retainers And Fasteners
    GM856569Courtesy of GENERAL MOTORS CORP.
  4. Install the engine cover (1).
  5. Secure the engine cover (1) with the 2 fasteners.

    Tighten:  Tighten the fasteners to 8.8 N.m (77 lb in).

  6. Install the 2 plastic retainers.
scientia non olet · About LEMON Manuals