Scan Tool Output Controls
Scan Tool Output Controls
| Scan Tool Output Control | Additional Menu Selection(s) | Description |
|---|---|---|
| Coolant Gauge Sweep Test | IPC Gauges | The IPC drives the coolant gage at or above 125°C (260°F) when you select Up. The IPC drives the coolant gage at or below 60°C (140°F) when you select Down. |
| Fuel Gauge Sweep Test | IPC Gauges | The IPC drives the fuel gage at or above full when you select Up. The IPC drives the fuel gage at or below empty when you select Down. |
| Speed Gauge Sweep Test | IPC Gauges | The IPC drives the speedometer at or above 200 km/h (120 mph) (base) or 220 km/h (140 mph) (uplevel) when you select Up. The IPC drives the speedometer at or below 0 km/h (0 mph) when you select Down. |
| Tach Gauge Sweep Test | IPC Gauges | The IPC drives the tachometer at or above 7000 RPM when you select Up. The IPC drives the tachometer at or below 0 RPM when you select Down. |
| Lamp Test | - | The IPC illuminates the following indicators when you select On:
The indicators should illuminate until commanded Off. |