Installation Procedure

Align the I/P outboard trim plate retainers to the slots in the I/P trim pad. Press the trim plate to the I/P trim pad.

Fig 1: View Of I/P Trim Plate

Courtesy of GENERAL MOTORS CORP.

Install the I/P accessory trim plate. Refer to Trim Plate Replacement - Instrument Panel (I/P) Accessory .

Fig 2: I/P Accessory Trim Plate

Courtesy of GENERAL MOTORS CORP.

If the I/P compartment is equipped with a dampener engage the door stop using the following procedure:
1. Press the upper door stop (2) toward the center of the vehicle.
2. Rotate the door up to the compartment.

Fig 3: View Of Upper Door Stop

Courtesy of GENERAL MOTORS CORP.

If the I/P compartment is not equipped with a dampener, install the door stop as shown.

Fig 4: I/P Compartment Door Stop

Courtesy of GENERAL MOTORS CORP.