LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2004 >> Grand Prix GTP >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel System Displays, Gauges And Console >> Repair Instructions >> Trim Plate Replacement - Instrument Panel (I/P) Accessory >> Installation Procedure

Installation Procedure

  1. Position the I/P center air outlet to the I/P accessory trim plate.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the I/P center air outlet screws.

    Tighten:  Tighten the screws to 2 N.m (18 lb in).

    3. Fig 1: I/P Center Air Outlet & Screws
    GM928622Courtesy of GENERAL MOTORS CORP.
  3. Place the driver information display on the I/P accessory trim plate
  4. Install the driver information display screws.

    Tighten:  Tighten the screws to 2 N.m (18 lb in).

  5. Connect the electrical connector to the driver information display.
    6. Fig 2: Electrical Connector & Driver Information Display
    GM928828Courtesy of GENERAL MOTORS CORP.
  6. Press the I/P accessory trim plate to the I/P.
    7. Fig 3: View Of I/P Accessory Trim Plate
    GM928809Courtesy of GENERAL MOTORS CORP.
  7. Install the ignition switch bezel.
    8. Fig 4: Identifying Ignition Cylinder Bezel
    GM910510Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals