Installation Procedure

Fig 1: View Of Compartment & Upper Trim Plate (Front Floor)

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the compartment screws.
Tighten: Tighten the screws to 2 N.m (18 lb in).

Fig 2: View Of Compartment & Screws (Front Floor)

Courtesy of GENERAL MOTORS CORP.

Fig 3: View Of Side Trim Panel Screws (Front Floor)

Courtesy of GENERAL MOTORS CORP.

Install the side trim panel screws.
Tighten: Tighten the screws to 2 N.m (18 lb in).
Install the compartment screws.
Tighten: Tighten the screws to 2 N.m (18 lb in).

Fig 4: View Of Compartment Screws (Front Floor)

Courtesy of GENERAL MOTORS CORP.

Fig 5: View Of Rear Cover (Front Floor)

Courtesy of GENERAL MOTORS CORP.

Fig 6: View Of Rear Cover Screws

Courtesy of GENERAL MOTORS CORP.

Install the armrest and the hinge. Refer to Console Armrest Replacement - Front Floor .
Install the accessory power receptacles. Refer to Cigar Lighter Housing Replacement - Floor Console and to Accessory Power Receptacle Replacement - Floor Console in Power Outlets.
Install the traction control switch. Refer to Traction Control Switch Replacement in Anti-lock Brake System.
Install the HUD switch, if equipped. Refer to Head Up Display Switch Replacement .
Install the wiring harness.
Install the cupholder liner.
Install the ashtray insert.
Install the floor console. Refer to Console Replacement - Front Floor .