Removal Procedure
- Remove the garnish moldings from the left and the right windshield pillars. Refer to Garnish Molding Replacement - Windshield Pillar in Interior Trim.
- Disengage the I/P upper trim panel retainers on the sides of the HUD.
- Disengage the retainer rearward of the HUD.
- Use your fingers to lift under the edge of the I/P upper trim panel adjacent to the trim clips. If equipped, disengage the trim panel retainers on the sides of the Head Up Display (HUD) first.
- Disengage the retainer rearward of the HUD.
- Disengage the remaining trim panel retainers. Lift the trim panel for access.
- Use clean shop towels to protect the I/P trim pad from the trim panel retainers. Rotate the Daytime Running Lamp (DRL) ambient light sensor.
- Remove the sensor from the trim panel.
- Rotate the Theft LED.
- Remove the LED from the trim panel.
- Remove the I/P upper trim panel.
NOTE:
Use the following method to disengage the Head Up Display (HUD) retainers. Do NOT pry the retainers with a flat-bladed tool or other similar device.
Failure to follow this method could break the tab on the HUD.
Failure to follow this method could break the tab on the HUD.