LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2004 >> Grand Prix GTP >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel System Displays, Gauges And Console >> Repair Instructions >> Knee Bolster Replacement - Right >> Installation Procedure

Installation Procedure

  1. Align the I/P passenger knee bolster the I/P carrier (cross car beam).

    Inboard bolster shown, outboard bolster similar.

    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Start the bolts by hand to avoid cross threading. Install the I/P passenger knee bolster bolts.

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

    3. Fig 1: I/P Passenger Right Knee Bolster
    GM929334Courtesy of GENERAL MOTORS CORP.
  3. Outboard bolster only. Connect the wiring harness retainers (1, 2) to the I/P passenger knee bolster.
    4. Fig 2: Wiring Harness Containers
    GM1204538Courtesy of GENERAL MOTORS CORP.
  4. Outboard bolster only. Install the I/P accessory wiring junction block. Refer to Junction Block Replacement - Accessory Wiring in Wiring Systems.
  5. Install the I/P trim pad. Refer to Trim Pad Replacement - Instrument Panel (I/P) .
scientia non olet · About LEMON Manuals