Installation Procedure
- Install the armrest and the hinge. Refer to Console Armrest Replacement - Front Floor .
- Install the accessory power receptacles. Refer to Cigar Lighter Housing Replacement - Floor Console and to Accessory Power Receptacle Replacement - Floor Console in Power Outlets.
- Install the traction control switch. Refer to Traction Control Switch Replacement in Anti-lock Brake System.
- Install the HUD switch, if equipped. Refer to Head Up Display Switch Replacement .
- Install the wiring harness.
- Position the floor console to the vehicle.
- Connect the electrical connector at the front of the floor console. Slide the floor console toward the front of the car.
- Install the shift handle. Install the shift handle screw.
- Shift the transaxle to P.
- Install the floor console bolts. Adjust the front seats as required.
Tighten: Tighten the bolts to 10 N.m (89 lb in).
- Release the park brake.
NOTE:
Refer to Fastener Notice
in Cautions and Notices.