Installation Procedure
- Align the I/P center compartment locator to the opening in the vehicle location antenna module bracket.
- Install the I/P center compartment to the I/P.
- Install the I/P center compartment screws.
Tighten: Tighten the screws to 2 N.m (18 lb in).
- Shift the transaxle to P.
- Press to release the park brake.
- Install the I/P accessory trim plate. Refer to Trim Plate Replacement - Instrument Panel (I/P) Accessory in Instrument Panel, Gages and Console.
- Install the ignition switch bezel.
NOTE:
Refer to Fastener Notice
in Cautions and Notices.