LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2004 >> GTO Automatic >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel System Displays, Gauges And Console >> Repair Instructions >> Knee Bolster Replacement - Left >> Removal Procedure

Removal Procedure

  1. Grab the upper edge of the knee bolster panel (2) and pull outwards to disengage the three retaining clips (3).
  2. Swing the knee bolster panel (2) open.
    3. IMPORTANT: When disengaging the knee bolster panel from the hinge clip, do not pull the left-hand side of the panel too far away from the instrument panel before disengaging the panel from the hinge pin on the right-hand side of the panel retainer.
  3. While holding each side of knee bolster panel (2), pull the left-hand side rearwards just enough to disengage it from the instrument panel knee bolster clip (1).
  4. Move the knee bolster panel (2) to the outboard side of the vehicle to disengage the retainer's pin from the panel and remove the panel from the vehicle.
  5. Remove the knee bolster reinforcement, if necessary. Refer to Knee Bolster Reinforcement Replacement .
    6. Fig 1: View Of Upper Edge Of Panel, Trim Panel & Retaining Clips
    GM1357924Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals