LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2004 >> GTO Automatic >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel System Displays, Gauges And Console >> Repair Instructions >> Instrument Panel (I/P) Retainer Replacement >> Installation Procedure

Installation Procedure

  1. Position the retainer (1) to the instrument panel, making sure the 2 lugs (2) are engaged.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the 3 screws (3) securing the retainer (1) to the instrument panel.

    Tighten:  Tighten the 3 screws to 2 N.m (18 lb in).

  3. Install the screw (4) securing the retainer (1) to the air duct.

    Tighten:  Tighten the screw to 2 N.m (18 lb in).

  4. Install the 2 screws (5) securing the data link connector (6) to the retainer (1).

    Tighten:  Tighten the 2 screws to 2 N.m (18 lb in).

  5. Install the knee bolster panel. Refer to Knee Bolster Replacement - Left .
  6. Install the left closeout/insulator panel. Refer to Closeout/Insulator Panel Replacement - Left .
    7. Fig 1: View Of Retainer, Data Link Connector, Lugs & Screws
    GM1358199Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals