LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2004 >> GTO Automatic >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel System Displays, Gauges And Console >> Repair Instructions >> Handle Replacement - Instrument Panel (I/P) Compartment >> Installation Procedure

Installation Procedure

  1. Install the lock cylinder to the compartment door handle, if removed. Refer to Lock Cylinder Replacement - Instrument Panel (I/P) Compartment Door .
  2. Install the instrument panel compartment door handle (1) to the reinforcement.
  3. Install the retainer (3) to the back of the instrument compartment door handle (1).
  4. Install the instrument panel compartment latch rod (2) to the instrument panel compartment latch handle (1).
    5. Fig 1: View Of Latch Assembly, Rod, Door Handle, Retainer & Screws
    GM1357457Courtesy of GENERAL MOTORS CORP.
  5. Clean the surface of the reinforcement (1) to remove all residual liner material and adhesive.
  6. Remove protective film from the new liner (4) and adhere the liner (4) to the reinforcement (1).
  7. Clean the surface of the reinforcement (1) to remove all residual absorber material and adhesive.
  8. Remove protective film from the new absorber (2) and adhere the liner (2) to the reinforcement (1).
  9. Install the reinforcement (1) to the instrument panel compartment door (3).
    10. NOTE: Refer to Fastener Notice in Cautions and Notices.
  10. Install the 9 screws (5) securing the reinforcement (1) to the instrument panel compartment door (3).

    Tighten:  Tighten the 9 screws to 2 N.m (18 lb in).

    11. Fig 2: View Of Reinforcement, Door, Absorber, Liner & Screws
    GM1357454Courtesy of GENERAL MOTORS CORP.
  11. Install the trim panel (3) to the instrument panel compartment door (2), making sure the retaining tabs that fasten the trim panel (3) to the instrument panel compartment door (2) are engaged.
  12. Install the 6 screws (1) attaching the trim panel (3) to the instrument panel compartment door (2).

    Tighten:  Tighten the 6 screws to 2 N.m (18 lb in).

  13. Install the instrument panel compartment door. Refer to Door Replacement - Instrument Panel (I/P) Compartment .
    14. Fig 3: View Of Door Trim, Door & Screws
    GM1357341Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals