LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2003 >> Vibe GT >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Engine Mechanical - 1.8L (LV6)) >> Repair Instructions >> On-Vehicle Repair Instructions >> Engine Block Heater Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Unclip the heater wire harness from the headlamp tab (1).
  2. Unclip the heater wire harness below the on the outside of the battery (2).
    Fig 1: Unclipping Heater Wire Harness
    G01546689Courtesy of GENERAL MOTORS CORP.
  3. On vehicles with automatic transmission, unclip the heater wire harness from the main wire harness.
    Fig 2: Unclipping Heater Wire Harness From Main Wire Harness
    G01546690Courtesy of GENERAL MOTORS CORP.
  4. On vehicles with manual transmission, unclip the heater wire harness from the main wire harness.
    Fig 3: Unclipping Heater Wire Harness From Main Wire Harness
    G01546691Courtesy of GENERAL MOTORS CORP.
  5. Unclip the heater cartridge from the engine block.
    Fig 4: Unclipping Heater Cartridge From Engine Block
    G01546692Courtesy of GENERAL MOTORS CORP.