Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Lubricate the front seal and the sealing surface of the crankshaft pulley with Chassis Grease GM P/N 1051344 (Canadian P/N 993037) or equivalent.
Install the crankshaft pulley onto the crankshaft indexing keyway.
NOTE: Refer to FASTENER NOTICE .
Install the crankshaft pulley retaining bolt using J 8614-01 to prevent crankshaft rotation when tightening the bolt.

Fig 1: Installing Crankshaft Pulley
Courtesy of GENERAL MOTORS CORP.

Tighten

Tighten the bolt to 142 N.m (105 lb ft).
Install the right splash shield.
Lower the vehicle.
Install the accessory drive belt. Refer to DRIVE BELT REPLACEMENT .
Connect the negative battery cable.
Tighten

Tighten the battery cable bolt to 15 N.m (11 lb ft).