LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2003 >> Vibe GT >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Engine Mechanical - 1.8L (LV6)) >> Repair Instructions >> On-Vehicle Repair Instructions >> Crankshaft Front Oil Seal Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Lubricate the new crankshaft front oil seal with Chassis Grease GM P/N 1051344 (Canadian P/N 993037) or equivalent.
  2. Using a hammer and an appropriate driver, lightly tap the crankshaft front oil seal into place.
    Fig 1: Installing Crankshaft Front Oil Seal
    G01546721Courtesy of GENERAL MOTORS CORP.

    Important:  Tap the oil seal in until its surface is flush with the crankshaft front oil seal retainer edge.

  3. Install the crankshaft pulley. Refer to CRANKSHAFT PULLEY REPLACEMENT  .
    NOTE: Refer to FASTENER NOTICE .
  4. Connect the negative battery cable.

    Tighten 

    Tighten the battery cable bolt to 15 N.m (11 lb ft).

  5. Start the engine.
scientia non olet · About LEMON Manuals